- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have problems getting Bluetooth to recognize voice commands. When I press the answer button on Bluetooth I get a "connected" message, not voice command options. Has anyone had this same problem? Thanks
Solved! Go to Correct Answer
Correct answers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If your Jabra Wave has been connected to any other device, I recommend that you reset it. This will clear out any previous settings and allow it to work with your current device.
Turn the headset ON. Then ’Press
and hold’ the volume down and answer/end buttons at the same
time for approx. 5 seconds until the battery icon and Bluetooth®
icon flash 5 times simultaneously - then the pairing list is reset.
- T urn the headset OFF. The next time you power on, the headset
will go into pairing mode
You can find other helpful instructions by clicking the link below. It will take you to the online manual for the Jabra Wave.
http://img4.jabra.com/sites/Jabra/GNImages/Products/Jabra_WAVE_UM_NA_11147.pdf
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If your Jabra Wave has been connected to any other device, I recommend that you reset it. This will clear out any previous settings and allow it to work with your current device.
Turn the headset ON. Then ’Press
and hold’ the volume down and answer/end buttons at the same
time for approx. 5 seconds until the battery icon and Bluetooth®
icon flash 5 times simultaneously - then the pairing list is reset.
- T urn the headset OFF. The next time you power on, the headset
will go into pairing mode
You can find other helpful instructions by clicking the link below. It will take you to the online manual for the Jabra Wave.
http://img4.jabra.com/sites/Jabra/GNImages/Products/Jabra_WAVE_UM_NA_11147.pdf