CR10000A DHCP change

[coreyf311]

I want to change the DHCP range to something other then 192.168.x.x and also the subnet.   However, I can not see where to change the subnet?  I can see where to change the IP address range but not the subnet.  This router is replacing my older Verizon router so I need to set it up the same as the one its replacing so all my devices stay connected as best as possible.

[Capricorn1 · Accepted solution]

I don't have the CR1000A myself, but I'm looking at the CR100A User Guide from 2023. Starting on pages 112-113 of that guide (Configuring the Home/Office Network), change the General --> IP Address to a new IP range (which should be an internal non-routable IP address like 192.168.7.1 or 10.3.4.1) and the appropriate Subnet Mask to match (255.255.255.0 for example - 10.x.x.x can use other Subnet Masks). Then go down to IP Address Distribution and change the Starting IP Address to the first available IP address you want the DHCP server to use (such as 192.168.7.2 or 10.3.4.2) and set the End IP Address to the last IP address you want the DHCP server to use (such as 192.168.7.180 or 10.3.4.180). You could leave an open range for static IP addresses (starting with 192.168.7.181 or 10.3.4.181 in my example).