G3100 does not have any way to enable/disable UPNP

[hubcapbrian]

After googling for videos, forum posts, etc. I cannot figure out how to make sure UPNP is disabled. Supposedly it is an option in the advanced settings but when I log into my G3100 it's not in the advanced settings.

My G3100 is running firmware version 3.1.1.18.

[dslr595148]

#1 Consider taking and showing a screen shot from Advanced in the NAT router.

Be aware that a mod/admin will have to approve of it, before any else can see it.

#2 While we get that you have FIos Internet, do you also have Fios TV One?

#3 Note: I might be so close but not quite = Fios One TV.

#4 For this next question even if you have one but not in use, you must say yes. For ex: Yes, but it is a spare.

#5 Do you have a separate RJ-45 WAN port NAT router?

#6 Do you have any spare computer(s) that works with at least two ethernet ports?

#7 Note: This can either be at least two NICs or only one NIC with more than one ethernet port.

[Cang_Household · Accepted solution]

OP, here it is.

[hubcapbrian]

All the info I found on the net showed it in Network Settings. How nice of Verizon to move it to a different menu #@$%^&

Thx for the answer!

[Cang_Household]

When I have time tomorrow morning, I will fact check your statement about relocation using the G1100's GUI.

[LawrenceC]

I would like to thank everyone for taking the time to post your comments and opinions related to this topic. This topic has been thoroughly discussed and will now be closed. Please feel free to open a new thread for further discussion. Thank you.