Having trouble with Westell 6100f modem....
TheKokNug
Newbie

It keeps on disconnecting on me... so I try to change it into bridge mode.... however when I try to set it up with my Netgear router... I kept on getting problems.

0 Likes
Reply
8 Replies
dslr595148
Community Leader
Community Leader

Points you to http://www.dslreports.com/faq/13600

Perhaps that may help you.

0 Likes
Reply
TheKokNug
Newbie

Ok so I bridged it, and currently mine uses a PPoE connection however, whenever I turn on my computer and try to connect to my router it says no internet connection..... Usually I have to wait about 15-30 minutes to get it or I don't get it at all.

As of now, something new and strange is happening..... the modem dsl is just flashing and the phone lines is scribbly... What the heck is going on?

0 Likes
Reply
dslr595148
Community Leader
Community Leader

Which Westell firmware (the While and Blue OR the Red and Black)?

0 Likes
Reply
TheKokNug
Newbie

I have the Red and Black

0 Likes
Reply
dslr595148
Community Leader
Community Leader

In the Westell while it is not in bridge mode go to System Monitoring -> Advanced -> Transceiver Statistics.

And post the results..

0 Likes
Reply
TheKokNug
Newbie

Uhh having slight trouble accessing the modem... I plug the ethernet cable into my computer... but it's not detecting it.

0 Likes
Reply
dslr595148
Community Leader
Community Leader

@TheKokNug wrote:

Uhh having slight trouble accessing the modem... I plug the ethernet cable into my computer... but it's not detecting it.


You have different options of getting into the modem while it is in bridge mode, let us do the method that you tried to do...

#1 You setup your computer to use the follow settings..

IP: 192.168.1.3

Subnet Mask: 255.255.255.0

As how to do that, there are different sites about it.

a) One of them is go to http://www.portforward.com/networking/staticip.htm

b) Select your OS, and follow the directions for setting a Static IP.

#2 Then with your web browser go to 192.168.1.1 and log-in as need be.

#3 When done getting the info from the modem while it is in bridge mode:

a) Disconnect your computer from the modem.

b) Set the comptuer back to the settings that it was set to use. This most likely, was DHCP.

c) Reconnect your computer, behind your other router.

--

For other method(s): I point to http://www.dslreports.com/faq/7267

I know that your other router is not a Linksys, but the Recommend and the Alternate method will work - with the expection of -


If the WAN Connection type is DHCP, then access to the modem should be possible without changing the settings in the router when the Internet is in an "up" state.

^^

0 Likes
Reply
TopGun
Enthusiast - Level 2

Just get a NEW 6100 modem from verizon problem solved!

0 Likes
Reply