- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In an attempt to cut expenses, I wanted to replace my Verizon router with one I purchased to avoid the monthly rental fee. As Verizon always referred to the router as a "router," I purchased a router - a NetGear XR1000 router. I open the box and the instructions from NetGear say to connect the router through the modem. The whole point of buying it was to return the Verizon box. I am not a tech person. I know the basics to survive, but this is over my head. Googling says Verizon doesn't use modems, it uses ONT, which I guess is the box in my basement. The current Verizon router connects with ethernet and not coax. I thought I could just plug the ethernet in (I followed the Verizon instructions to release the DHCP lease) and be good to go, but it keeps saying no internet. Is there no way to connect this Net Gear router and I've purchased the wrong thing? I do have internet only, no TV or phone service.
Solved! Go to Correct Answer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Connecting the Netgear router should be just as simple as disconnecting the FiOS router and connecting your own router. Just make sure the Ethernet cable from the FiOS ONT connects into the Netgear router via the port designated for Internet. The Netgear router by default should be set to use DHCP/Auto mode, and that is what Verizon uses. Might need to be a little patient.
Verizon does provide a small grace with how many IP addresses you can pull. Performing a DHCP Release isn't needed in most markets now.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Connecting the Netgear router should be just as simple as disconnecting the FiOS router and connecting your own router. Just make sure the Ethernet cable from the FiOS ONT connects into the Netgear router via the port designated for Internet. The Netgear router by default should be set to use DHCP/Auto mode, and that is what Verizon uses. Might need to be a little patient.
Verizon does provide a small grace with how many IP addresses you can pull. Performing a DHCP Release isn't needed in most markets now.