IPC1100 own router - MOCA adapter
Kipperm13
Newbie

Hi everyone,

I need some help here. I currently have FIOS gigabit with FIOS TV and phone.   I have my own router setup with UniFi Dream Machine Pro (UDM-Pro) and a 24-Port managed PoE switch.  I have the internet up and running with no issues. 

ONT Cat6  -> UDM-Pro -> USW-24-POE 

However my issue is with the FIOS TV.  I tired using the FIOS G1100 router but after sometime trying to set up in bridge mode I gave up and just go a actiontec ecb6200 MOCA adapter.  I was able to get the VMS1100 to work right away with VOD and TV guide all working.  However I can't get the remote STB IPC1100's to see the media server.  I get a message "Unable to connect to Media server"  

My setup is 

ONT Coax -> 4 way Splitter ->

Split 1 -  actiontec ecb6200 -> VMS1100 -  This is working VOD and TV guide

Split 2- IPC1100 - not working.  I tired adding a second actiontec ecb6200 here but also didn't work. 

** Note the ecb6200 is also connected to a port on the switch to get the internet working. 

From the network switch I am able to see both the VM1100 and the IPC1100 and they both have a IP on the same subnet 192.168.80.X 

Any help would be great.  

0 Likes
Reply
1 Solution
Edg1
Community Leader
Community Leader

@Jrm1328 wrote:

My setup is 

ONT Coax -> 4 way Splitter ->

Split 1 -  actiontec ecb6200 -> VMS1100 -  This is working VOD and TV guide


Does the VMS1100 connect to the TV/STB out port here? That port range is 5 - 1002 MHz. MoCA operates at 1150 MHz. That may be your issue. Run the VMS1100 and ECB6200 directly from the 4 way splitter. Or place a 2 way at the wall jack and connect one out to the VMS and other out to the 6200. 

View solution in original post

4 Replies
Edg1
Community Leader
Community Leader

@Jrm1328 wrote:

My setup is 

ONT Coax -> 4 way Splitter ->

Split 1 -  actiontec ecb6200 -> VMS1100 -  This is working VOD and TV guide


Does the VMS1100 connect to the TV/STB out port here? That port range is 5 - 1002 MHz. MoCA operates at 1150 MHz. That may be your issue. Run the VMS1100 and ECB6200 directly from the 4 way splitter. Or place a 2 way at the wall jack and connect one out to the VMS and other out to the 6200. 

Cang_Household
Community Leader
Community Leader

When you have a DVR, the general rule is that a Verizon primary router is required.

G1100's NAT speed and throughput speed are fine. You can put your router behind G1100 with double NAT.

Kipperm13
Newbie

There are a number of people who have a setup without the Verizon router.  Really don't want to have the G1100 in the setup

0 Likes
Reply
pish180
Newbie

Did you end up getting it working?   I have a very similar setup however my FIOS comes in via Ethernet from the ONT.  

0 Likes
Reply