An Accepted Solution is available for this post.
Repurposing Fios Router to Send Signal to My STB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I’m using a LynkSys 1900 to replace my Fios router, I’m repurposing the Fios router to send signal to my stb. I can see the gateway on my map, but when I power on my stb (after reboot), the gateway disappears and my stb are limited (no on demand etc.). Any suggestions? Am I turning on the stb too soon? Thanks
1 Reply
An Accepted Solution is available for this post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you configured your FIOS router as a bridge?
And have you configured the linksys porperly?
Check the thread on using your own router.