- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe I'm blind but I can see no way to edit a port forwarding rule on the Actiontec Rev I firmware 4.21.10.3. The edit option existed on the Westell that this actiontec replaced and I can't believe that they would remove such a thing.
Pain to have to keep re-entering multiple port forwardings in a single rule set up for 1 machine.
Anybody know if there is some hidden page that allows update?
Solved! Go to Correct Answer
Correct answers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No hidden page that I know of.
The edit functionality was taken out in a firmware update quite awhile back.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No hidden page that I know of.
The edit functionality was taken out in a firmware update quite awhile back.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, thanks for the info..
Kind of an odball thing to do but maybe there was some reaon, As I run in a double nat setup I setup rules to open multiple machines via the internal router with one rule covering multiple ports and then added a secondary rule at the secondary internal router. Then today discovered I could not edit the rule to add one extra machine with a new port without re-entering everyting, or else setting up a totally new rule for the one machine. Seems a somewhat odd restriction!