- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am currently on release 1.9 build 10.95. Ever since the software was "upgraded" I have noticed the following:
Intermittently, when changing channels, by selecting from the guide, often the system will hang, for up to a minute, before the channel finally changes, almost as if it is waiting for something to time out.
Intermittently, when I use the remote, the green light will flash on the box showing that a signal has been received, but nothing happens. I may have to issue the command two or three times.
This has happened on all three of our DVR's - Motorola QIP - 7216 1
I have reset the box via software, physically reset the box by pulling the power chord, and put new batteries into the remote, numerous times, and the problem persists.
Is it only me, or has this problem been reported under a different heading?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content