- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all.
I believe the G1000 has a coax cap of 500mbps for the MoCa network.
In attempting to bypass the coax cap, I am bringing in a ECBM5240 and connecting it to the G1000 via ethernet and then using the ECBM5240 Coax to drive more bandwidth.
One thing I'm noticing is that when i have the ECBM5240 on the network, I am getting connection issues with dropped packets on my network. Essentially every 45-60 seconds, I get 3 dropped packets. I tested this via wired ethernet directly to the various WCB6200Q I have on the MoCa network.
This is what I see when I ping Bing.com via a command prompt:
C:\Users\jb007> ping -t wwww.bing.com
Pinging dual-a-0001.a-msedge.net [13.107.21.200] with 32 bytes of data:
Reply from 13.107.21.200: bytes=32 time=14ms TTL=118
Reply from 13.107.21.200: bytes=32 time=7ms TTL=118
Reply from 13.107.21.200: bytes=32 time=7ms TTL=118
Reply from 13.107.21.200: bytes=32 time=5ms TTL=118
Request timed out.
Request timed out.
Request timed out.
Reply from 13.107.21.200: bytes=32 time=14ms TTL=118
Reply from 13.107.21.200: bytes=32 time=7ms TTL=118
Reply from 13.107.21.200: bytes=32 time=7ms TTL=118
Reply from 13.107.21.200: bytes=32 time=5ms TTL=118
Ping statistics for 13.107.21.200:
Packets: Sent = 11, Received = 8, Lost = 3 (27% loss),
Approximate round trip times in milli-seconds:
Minimum = 5ms, Maximum = 14ms, Average = 8ms
If I let the results run for hours, i see the 3 "Request timed out" happen over and over every minute. It makes it impossible to maintain a Zoom, Team, or Hangouts call stable.
The current config I have is the following:
OTN ----ethernet----G1000 ----ethernet----ECBM5240 ----coax---- WCB6200Q (5 devices)
Any thoughts of what could be causing this?
Thanks!
Solved! Go to Correct Answer
Correct answers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is the G1100 still connected to the same Coax network as your ECBM5240? It sounds like you may have a loop and the router is running Spanning Tree to disable one network interface and enable the other. Make sure Coax LAN is disabled on the G1100 or, just unplug the Coax all together from it if you're not using it.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What do you see if you reduce the active MoCA nodes?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I haven’t tried that - is there a limit? I’m away, but will return on Sunday and will test it out.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is the G1100 still connected to the same Coax network as your ECBM5240? It sounds like you may have a loop and the router is running Spanning Tree to disable one network interface and enable the other. Make sure Coax LAN is disabled on the G1100 or, just unplug the Coax all together from it if you're not using it.