router vs extender?
potsyDC
Enthusiast - Level 1

I just realized I accidentally purchased a new Router (G1100) to extend my Verizon Fios internet setup instead of an actual Extender (WCB6200Q). My plan was to make use of a MOCA setup to boost wifi in the house. Question now is, do I send back the router and buy the extender, or keep the router to achieve the same purpose?

0 Likes
1 Solution

Correct answers
Re: router vs extender?
dslr595148
Community Leader
Community Leader

Not sure, but between the two.  I guess keep the router to achieve the same purpose

REF https://www.dslreports.com/faq/11233

#1 In the primary NAT router:

a) find the DHCP Range.

b) Make sure that it does not occupy the whole subnet.

c) If it occupy the whole subnet, make it smaller.

For example with it at 192.168.1.1 with the subnet mask of 255.255.255.0, the first DHCP Address that it handles out is 192.168.1.2 and the last DHCP Address that it handles out is 192.168.1.254 - then you could change it so that the first DHCP Address that it handles out is 192.168.1.100 and the last DHCP Address that it handles out is 192.168.1.254 

#2 For that other router, you must:

a) Have it disconnected at this step.

b) Set it's LAN IP Address with the same Subnet as the primary but outside of the DHCP Range of the Primary router's DHCP Range.

For example with the primary IP Address 192.168.1.1 with the subnet mask of 255.255.255.0, the first DHCP Address that it handles out is 192.168.1.100 and the last DHCP Address that it handles out is 192.168.1.254 - then the other router's LAN IP Address could be 192.168.1.6

c) Disable the DHCP Server in the second RJ-45 WAN port NAT router.

#3 Once you make those changes, now you can connect both of those routers together but this time LAN to LAN.

View solution in original post

Re: router vs extender?
dslr595148
Community Leader
Community Leader

Not sure, but between the two.  I guess keep the router to achieve the same purpose

REF https://www.dslreports.com/faq/11233

#1 In the primary NAT router:

a) find the DHCP Range.

b) Make sure that it does not occupy the whole subnet.

c) If it occupy the whole subnet, make it smaller.

For example with it at 192.168.1.1 with the subnet mask of 255.255.255.0, the first DHCP Address that it handles out is 192.168.1.2 and the last DHCP Address that it handles out is 192.168.1.254 - then you could change it so that the first DHCP Address that it handles out is 192.168.1.100 and the last DHCP Address that it handles out is 192.168.1.254 

#2 For that other router, you must:

a) Have it disconnected at this step.

b) Set it's LAN IP Address with the same Subnet as the primary but outside of the DHCP Range of the Primary router's DHCP Range.

For example with the primary IP Address 192.168.1.1 with the subnet mask of 255.255.255.0, the first DHCP Address that it handles out is 192.168.1.100 and the last DHCP Address that it handles out is 192.168.1.254 - then the other router's LAN IP Address could be 192.168.1.6

c) Disable the DHCP Server in the second RJ-45 WAN port NAT router.

#3 Once you make those changes, now you can connect both of those routers together but this time LAN to LAN.