Several weeks ago, my service was converted from copper to FiOS. The conversion was seamless. Today, I lost my dial tone. After following instructions from Chat, the dial tone was recovered. As I replugged my hand sets, all worked well until I plugged in my most recently purchased Uniden DECT 6.0 Cordless set. I immediately lost the dial tone until I disconnected the handset. This set worked just fine until today. What gives?
Possibly a bad wire, or flaw in the Uniden phones base station. I've used several versions of Uniden dect 6.0 phones in the past with no problems.
Remember these forums are peer to peer.
Start a new topic or ask questions in the open forum.
