Receive up to $504 promo credit ($180 w/Welcome Unlimited, $360 w/ 5G Start, or $504 w/5G Do More, 5G Play More, 5G Get More or One Unlimited for iPhone plan (Welcome Unlimited and One Unlimited for iPhone plans can't be mixed w/other Unlimited plans; all lines on the account req'd on respective plans)) when you add a new smartphone line with your own 4G/5G smartphone on an eligible postpaid plan between 2/10/23 and 4/5/23. Promo credit applied over 36 months; promo credits end if eligibility requirements are no longer met.
$699.99 (128 GB only) device payment purchase or full retail purchase w/ new smartphone line on One Unlimited for iPhone (all lines on account req'd on plan), 5G Start, 5G Do More, 5G Play More or 5G Get More plan req'd. Less $699.99 promo credit applied over 36 mos.; promo credit ends if eligibility req’s are no longer met; 0% APR.
I have a DVR/media center with two additional STBs. Before Gibabit installation on a STB I could change from channel one to channel two and then back to channel one and rewind up to an hour. The red line on both channels would have the previous hour to rewind. This functionally is gone after the Gigabit installation. Does anyone know how to resolve this without always recording shows? Has anyone else experienced this loss of service?
What model STB do you have?
Have you tried rebooting it?
Internet should not play in TV controls.
Gigabit ONT - Cat 6 and Coax to G1100 Router
DVD Media Center - Arris VMS1100
STBs - IPC1100 P2
1. I called support and they had me unplug everything for two minutes and then bring it up from outside through DVR to STBs. No change.
2. They have the setup in the support center and told me that it could never have worked the way it was. I was told that the only way to rewind is to hold the tuner (another STB/DVR watching) or to record.
It may depend on how many tuners are in use.
If both ipcs are one and you have stuff recording, there may only be one tuner left.
Appears to work at least on my VMS. Not sure if it works that way on ipcs.
I have five or six tuners. This still happens with just on STB turned on.
I'll give kudos to anyone that answers / solves the problem.
You can try giving them manual cold inits starting with the VMS then moving to the IPs
Unplug the VMS and as soon as you plug back in keep pressing menu on the remote until the displays reads I think “run”. Then use the down arrow until you get to “cold”. Then press ok. Will take about 10 min once done if that fixed it then move on to the IPs.
Keep in mind cold init will factory reset all settings. Before you do that, export series to cloud. Will save all of your series settings.
And if you use similar settings on all boxes, you can import setting from one into the VMS, then import from it to each other boxes.