Using http://192.168.1.1/.
Service recently setup. Using default user id & password in order to login for first time. Won't let me login in order to turn off wi-fi. Any suggestions?
@vzncust11 wrote: Using http://192.168.1.1/.Service recently setup. Using default user id & password in order to login for first time. Won't let me login in order to turn off wi-fi. Any suggestions?
Default user ID = admin
password = serial number of your router. It is found on the sticker attached to the bottom of your router.
If it is an older router and it has been reset password = password. Some techs used to setup as password1, but that was stopped.
If you reset your router it should default to the serial number. Only the Very Old routers defaulted to password, and it was a security risk.
Also ignore the extra characters it shows when you type your password. They are a security feature.
the new dual band antenna'd routers from verizon have the password written on the router and labeled as login password.
So if you have the red band dual antenna, then look for that, the older ones, as prisaz has pointed out, use the serial number under the UPC bar code of the router, and it IS case sensitive.
@Hubrisnxs wrote: the new dual band antenna'd routers from verizon have the password written on the router and labeled as login password.So if you have the red band dual antenna, then look for that, the older ones, as prisaz has pointed out, use the serial number under the UPC bar code of the router, and it IS case sensitive.
Thanks for the information. I may see one of these routers at some point. Don't plan on buying one. May see one if I ever go GPON. Otherwise my switches are just fine on the LAN.
My 300N Access Point will cover many square feet, also has a power adjustment so if I don't want the neighbors down the street hitting it, I can cut it back. Which I have not. WAP2. I turned off the wireless on my Rev. E.
The wireless N on the new verizon routers is only 16mb, so you are sitting pretty with your 300 🙂
