SIM CARD INSTALLATION AND REMOVAL

[B33]

When installing or Removing a Sim Card Make sure You Use Caution: When holding the Sim do it by it's Edges an do not Touch any of the Gold surface as it extremely Sensitive to Static Electricity.

Note:  the Reason i wrote this post was to make it aware to new owners to 4G an the Sim Card Especially the Mini Sim as it can be on the difficult side to remove it from the Holder.  When i removed mine from the holder i used a x-acto knife with a No.11 blade it came out easy an when i installed it in my Razr i put it in as described but i used a Toothpick cut to wear it had a blunt face on it. I then put the toothpick up against the Sim an then pushed it in the rest of the Way.

[B33]

Update: I Want to add to my Original Post that in the event of needing to remove the Sim card for phones that are un-responsive to the Network or any other issue the same caution needs to be practiced. Or the card & or the phone might not work properly or at All. B33

[3doxiemom]

Warning, it's also VERY EASY to put it in upside down - which I just realized I did! I got an error that "A SIM card is needed to operate this phone. Please turn off your phone and insert your SIM card." I turned off my phone, tried to put it in with the gold side up, couldn't get it to fit.   Finally, after trying a couple more times, it slid right in! Now, all is working on my phone again! Remember -- GOLD side UP!

[B33]

Yup that is Why i Maid the Suggestions i Did,, however at the time i wrote these suggestions i did leave out the card needed to installed Gold Side Up.. i wrote that in a later Post.. but leaving the Front static sticker on the Device is a Must until the Card is installed so that what happened in your case doesn't happen to Customers that buy a Razr or Maxx..