Does the CR1000B router support Dot1Q on its 10ge int?

greptheloot

Hello, before I go screwing around I was wondering if the CR1000B router will route vlan traffic through it's 10ge int, uplinked from a Catalyst switch SFP. Unclear if the router 10ge int is configured as a trunk.

Only asking because I don't see any vlan settings in the router GUI, nor the documentation, however the doc does say Quality of Service supports 802.1q prioritization. Also I'd imagine the options for IoT and Guest SSIDs are segmented from the primary LAN with vlans? If that is the case, what numbers are used?

Thanks in advance!

Cang_Household

GUI VLAN settings were available on BHR 3, but was axed on BHR 4 (G1100) and onward.

Since you mentioned Catalyst, I am assuming you have network engineering backgrounds.

IoT WAP is not segmented from the main network. Guest WAP is on VLAN 10 with prefix 192.168.200.0/24. There are also VLAN 20 and VLAN 30 on 192.168.150.0/24 and 192.168.250.0/24, respectively (I think), but I don't recommend their use.

All LAN ports are trunked and tagged for VLANs 10, 20 and 30.

You can add a Layer 3 switch behind the router and make it route.

Verizon routers have the following NAT setting

iptables -t nat -A POSTROUTING -o eth1 -j MASQUERADE

So it will perform masquerading on all subnets. Verizon routers also support static routing, so point the subnets on the L3 switch on the Verizon router.