Netgear Orbi or FiOS Network Extender

I have dead zones with the Quantum Gateway. It's worse with this gateway than the one provided by Comcast, to the point areas of my home are unusable. I've been in the market to fix this but it was tolerable on Comcast, intolerable now with FiOS. I'm considering the Netgear Orbi. Should I do the Orbi mesh router or the FiOS network extender? I'm looking for the best combination of latency and speed. I don't care about the fastest speed if the latency is higher.

I stream content using AppleTV/Chromecast/Firestick and otherwise just have laptops, PCs, and mobile devices accessing the internet for content consumption. We don't do any online gaming. I have FiOS gigabet ethernet and my speeds are roughly 900/900 Mbit to the house. In good areas of my house with the Quantum gateway, I'm seeing 80/80 Mbps but I have parts of my home where the 2.4 GHz is too slow to be useable and the 5GHz can't be seen so I've got to do something.

Accepted answers

Capricorn1

Since you have coax throughout the house both the network extender or the Netgear Orbi should work. I will throw out there that there are other mesh network vendors out there as well and here is a comparison from PC Magazine and this guy. I would probably go with the mesh network. I believe the Verizon network extender either by using the coax or wireless connection, just picks up and rebroadcasts any wireless signals it receives - essentially putting additional traffic on the wireless network. As I understand it, mesh networks hand off the connection to wireless devices to whichever node has the best signal and can seamlessly switch nodes as the device moves about (e.g., laptops and cell phones).

If you go the Orbi (or another mesh network) route, I would shut off the wireless in the G1100 Quantum router and put the Orbi in AP mode. I'm sure the other mesh vendors have similar ways to do that. (Download their user manuals and look for bridge mode and access point mode.)

Also, with either the extender or the mesh network, you (probably) also just put a wired Ethernet port in the room where the base/node is. I have Rokus hardwired by Ethernet, but I'm not sure if your streaming devices have Ethernet. If they do, you could use that, shut off the wireless on those devices and let the mesh network (or coax network on the extender) do the wireless part. That gets some competing wireless devices off the wireless network.

All comments

Edg1

It really depends on your situation. FiOS extenders need wiring to connect to them were Orbi does not and you can use Orbi with any service.

MDTerp429

I have coax outlets on every level of my home, just no ethernet. The range extenders use the coax, right? I guess I'm just trying to figure out/understand if going wired over the coax is inferior to mesh or if the mesh will just be much better to make it worth the difference in price.

Edg1

They do use coax but I’ve seen posters on here say the wifi is just ok on them. Verizon also sells Orbi now. I think Orbi has better WiFi plus if you need to add one you can at a later time plus if you ever use another provider you be able to re use you Orbi.

Capricorn1

MDTerp429

Very helpful, thank you both for the input! I will check out the alternative mesh solutions. If I do a bonded 2.0 MoCA adapter and 2 extenders, this will be about the same price as some of the alternate mesh solutions. I'm not really worried about the cost driving the decision, though. I'm more looking for what is going to give me the best overall performance.

I was looking at buying the Orbi from Verizon but now I'm a little nervous as it says the updates come from Verizon and it's not compatible with non-Verizon satellites. Thoughts or experience?

Edg1

I would get it from Netgear. If Verizon has their software on it. It sounds like they have their own software on there.

The bonded 2.0 adapter is really only beneficial is you have 2. One on each end to get gig speed.

MDTerp429

@Edg1 wrote:
I would get it from Netgear. If Verizon has their software on it. It sounds like they have their own software on there.
The bonded 2.0 adapter is really only beneficial is you have 2. One on each end to get gig speed.

Thanks, I think I am going to just get it from Netgear. I don’t trust Verizon running my updates.

I was considering the bonded adapter on the Verizon router end and a network extender on the other end. I believe this would give me a wired connection up to 700 Mbps at the extender along with the wireless. I still may do this to be honest. I’m jonesing for a reasonably fast wired connection to my NAS.